Siemens Simatic S7-1500

Hardware section
2.1 Introduction
S7-1500
16 Getting Started, 05/2014, A5E03981761-AC
Software requirements
To implement the software section of this Getting Started, you will need:
● SIMATIC STEP 7 Professional V13
● SIMATIC WinCC Advanced V13 or SIMATIC WinCC Professional V13
WARNING
Severe personal injury may result
The S7-1500 automation system in plants or systems is governed by specific standards
and regulations, based on the relevant field of application. Please observe the applicable
safety and accident prevention regulations such as IEC 60204-1 (general machine safety
requirements).
Failure to observe these regulations can result in serious injuries and damages to
machinery and facilities.
2.1.2
Additional information
Detailed information on the hardware used is available here:
● CPU 1511-1 PN (6ES7511-1AK00-0AB0)
(http://support.automation.siemens.com/WW/view/en/68020492)
● S7-1500 load current supply PM 70W 120/230VAC (6EP1332-4BA00)
(http://support.automation.siemens.com/WW/view/en/68036174)
● DI 16x24 V DC SRC BA digital input module (6ES7521-1BH50-0AA0)
(http://support.automation.siemens.com/WW/view/en/59191844/)
● DQ 16x24 V DC/0.5A ST digital output module (6ES7522-1BH00-0AB0)
(http://support.automation.siemens.com/WW/view/en/59193401)