Siemens Simatic S7-1500

Software section
3.2 Creating the program
S7-1500
Getting Started, 05/2014, A5E03981761-AC
51
3.2.3
Copying program blocks
Introduction
In the following section, you will insert the program blocks from the
"ProgLib_ColorFillingStation" global library into your project.
Procedure
1. Click on global library "ProgLib_ColorFillingStation".
2. Click the "Master copies" folder and then on "Programm_blocks".
3. Drag-and-drop the program block to be imported from the global library to the "Program
blocks" folder.
4. Proceed as described in steps 2 and 3 for the other blocks.
Result
The program blocks are inserted in the project folder of the same name.