Siemens Simatic S7-1500 - Page 53

Properties of a DRIVE-CLiQ interface
Table 4-9DRIVE-CLiQ interfaces X100 to X103
Property Version
Connector type DRIVE-CLiQ connector (RJ45 socket)
Cable type, inside the control cabinet DRIVE-CLiQ standard
Cable type, outside the control cabinet MOTION CONNECT
Blanking plug for closing unused DRIVE-CLiQ inter
faces
Blanking plugs are included in the scope of delivery
of the SIMATIC Drive Controller.
Additional blanking plugs are available as accessor
ies.
NOTE
The maximum permissible cable length is 100m.
Pin assignment of a DRIVE-CLiQ interface
Table 4-10Pin assignment of DRIVE-CLiQ interfaces X100 to X103
View Pin Signal
name
Type of signal Meaning
1 TXP Output Transmit data +
2 TXN Output Transmit data -
3 RXP Input Receive data +
4 - - Reserved; no connection
5 - - Reserved; no connection
6 RXN Input Receive data -
7 - - Reserved; no connection
8 - - Reserved; no connection
A + (24V) Voltage Output Voltage supply for DRIVE-CLiQ,
≤ 450mA
8
1
A
B
B M (0V) Voltage Output Ground for 24V
53
Connecting
4.5 DRIVE-CLiQ interfaces X100 to X103
SIMATIC Drive Controller
Equipment Manual, 11/2022, A5E46600370-AC