Siemens Simatic S7-1500

Technical specifications
6
Technical specifications of SIMATIC Drive Controller
The following table shows the technical specifications as of 11/2022. You will find a data
sheet including daily updated technical specifications on the Internet:
•
CPU 1504D TF
(https://support.industry.siemens.com/cs/ww/en/pv/6ES7615-4DF10-0AB0/td?dl=de)
•
CPU1507DTF
(https://support.industry.siemens.com/cs/ww/en/pv/6ES7615-7DF10-0AB0/td?dl=de)
Article number 6ES7615-4DF10-0AB0 6ES7615-7DF10-0AB0
General information  
Product type designation CPU 1504D TF CPU 1507D TF
HW functional status FS11
Firmware version PLC: V3.0 / SINAMICS Integrated: V5.2 SP3
Product function  
•
I&M data Yes; I&M0 to I&M3
•
Isochronous mode Yes; With minimum OB 6x cycle
of 500 µs
Yes; with minimum OB 6x cycle
of 250 µs
Engineering with  
•
STEP 7 TIA Portal configurable/integrated
from version
V18 (FW V3.0) / V16 (FW V2.8) or higher
Integrated drive control  
•
Number of axes for servo control, max. 6
•
Number of axes for vector control, max. 6
•
Number of axes for V/f control, max. 12
•
Remark alternative control modes; drive control based on SINAMICS S120
CU320-2 (firmware version V5.x); functional subset compared to
CU320-2: no free function blocks, ... ; for details, see the manual
Configuration control  
via dataset Yes
Control elements  
Number of keys 1; FUNCT button
Mode selector switch 1
Supply voltage  
Rated value (DC) 24V
permissible range, lower limit (DC) 20.4V
permissible range, upper limit (DC) 28.8V
Reverse polarity protection Yes
power supply according to NEC Class 2 required No
Mains buffering  
•
Mains/voltage failure stored energy time 3ms; Refers to the power supply on the CPU section
65
SIMATIC Drive Controller
Equipment Manual, 11/2022, A5E46600370-AC