Siemens Simatic S7-1500 - Page 80

Article number 6ES7615-4DF10-0AB0 6ES7615-7DF10-0AB0
Isolation  
Isolation tested with 707 V DC (type test)
Degree and class of protection  
IP degree of protection IP20 control cabinet installation / open type
Standards, approvals, certificates  
CE mark Yes
UKCA mark Yes
cULus Yes
RCM (formerly C-TICK) Yes
KC approval Yes
EAC (formerly Gost-R) Yes
Suitable for safety functions Yes; e.g. emergency stop, acknowledgment button
Highest safety class achievable in safety mode  
•
Performance level according to ISO 13849-1 PLd (PLe if exclusively F-CPU is used)
•
SIL acc. to IEC 61508 SIL 2 (SIL 3 if exclusively F-CPU is used)
Probability of failure (for service life of 20 years
and repair time of 100 hours)
 
–
Low demand mode: PFDavg in accord
ance with SIL2
< 14.00E-04
–
Low demand mode: PFDavg in accord
ance with SIL3
< 2.00E-05 PLd (if exclusively F-CPU is used)
–
High demand/continuous mode: PFH in
accordance with SIL2
< 14.00E-09
–
High demand/continuous mode: PFH in
accordance with SIL3
if exclusively F-CPU is used: < 1.00E-09 (at a site altitude of up to
3000 m); < 2.00E-09 (at a site altitude of more than 3000 m and up
to 4000 m)
Ambient conditions  
Ambient temperature during operation  
•
min. 0°C
•
max. 55°C
Ambient temperature during
storage/transportation
 
•
min. -40°C; Long-term storage: -25 °C
•
max. 70°C; Long-term storage: +55 °C
Altitude during operation relating to sea level  
•
Installation altitude above sea level, max. 4000m; as of an altitude of 2000 m, the maximum ambient air tem
perature is reduced by 7 °C per 1000 m; see SINAMICS documenta
tion for SINAMICS S120 drive components
•
Ambient air temperature-barometric pres
sure-altitude
Permissible air pressure: 620 hPa ... 1 060 hPa
configuration / header  
configuration / programming / header  
Programming language  
80
SIMATIC Drive Controller
Equipment Manual, 11/2022, A5E46600370-AC
Technical specifications