Siemens Simatic S7-1500H - Page 152

Connecting HMI devices over Industrial Ethernet, example with CPU1513R‑1PN
The figure below shows how to connect an HMI device over Industrial Ethernet with the
CPU1513R‑1PN.
5*"
+0,
6ZLWFK
6ZLWFK 6ZLWFK
,QGXVWULDO(WKHUQHW
(QJLQHHULQJVWDWLRQ
3$16 3$16
Figure 5-50Configuration example CPU 1513R-1 PN: Connecting the HMI device via a switch
CPU1513R‑1PN has a PROFINET IO interface with 2 ports (X1P1RR and X1P2R).
To connect an HMI device to the CPUs over Industrial Ethernet, you set up the PROFINET ring
over PROFINET interface X1. Integrate a switch into the PROFINET ring. Use this to establish
an Industrial Ethernet connection.
You can find additional information on the interfaces of CPU1513R‑1PN in the relevant
device manual.
Reference
You can find more information on the system IP address in the section Configuration process
and in the Communication (https://support.industry.siemens.com/cs/ww/en/view/59192925)
function manual.
More information on how to set up an HMI connection to the S7-1500R/H redundant system
is available in the Communication
(https://support.industry.siemens.com/cs/ww/en/view/59192925) function manual.
See the following entry (https://support.industry.siemens.com/cs/ww/en/view/109781687)
for an example of how to connect an HMI device with S7-1500R/H.
152
S7-1500R/H redundant system
System Manual, 11/2022, A5E41814787-AD
Application planning
5.7 Using HMI devices