Commissioning FM 350-1
6.2 Procedure for assigning parameters
FM 350-1 Counter module
82 Manual, 05/2011, A5E03648639-01
Working step Options/Procedure ✓
Determine the behavior of the digital inputs
Level-controlled hardware gate HW gate
Edge-controlled hardware gate
≥2.5 μs Minimum pulse width
≥25 μs
Determine the behavior of the digital outputs
Low limit
High limit
No comparison
Out of limits
Below the low limit
Output DO0
Above the high limit
Select interrupts
Interrupt on opening the gate (hardware or software gate)
Interrupt on closing the gate (hardware or software gate)
Interrupt on violation low limit
Interrupt on violation high limit
Configuring FM 350-1 in
HW Config
Interrupt at end of measurement
Enable digital outputs
CTRL_DO0 in DB
CTRL_DO1 in DB
Determine load value and comparison values and enter in DB
Low limit
High limit
Update time
Integrate FCs in user program
Integrate FC CNT_CTL1 or FC CNT_CTL2
In the S7 user program
Integrate FC DIAG_INF
To Next Page
Loading...
