Operating Modes, parameters and commands
7.3 Count modes
FM 350-1 Counter module
92 Manual, 05/2011, A5E03648639-01
Terminating the Count with the Gate Stop Function
You can also terminate the count when counting with the software gate or hardware gate by
using the gate stop function. Set the GATE_STP input parameter of FC_CNT_CTL1 for this.
Effects of the Latch Setting on the Counter at the Beginning of a Count Operation
You can find information on this in the section command: Latch/retrigger (Page 127) and
command: Latch (Page 130) in this section.
To Next Page
Loading...
