Siemens Simatic S7-400 - Page 52

Time switch based on the S7-300/400 CPUs with simple HMI system
including radio-controlled clock connection
Rev. B - final 19.07.2002 52/84
Copyright © Siemens AG 2005 All rights reserved
BID21669756_Zeitschaltuhr_einfach_DOKU_v20_e.doc
Step Action Screenshot
4.
Make the necessary settings for the
transfer operation. Open the menu
“Datei > Transfer >
Einstellung...“ [File >
Transfer > Settings...].
5.
Select “MPI/PROFIBUS DP“ and
enter the OP address, “1“ in this
example.
Note:
The OP address must be identical
with the network parameterization in
ProTool. The settings are made
under “Controls”.
6.
Start the project transfer via the
menu “File -> Transfer ->
Start project transfer“.