Time switch based on the S7-300/400 CPUs with simple HMI system
including radio-controlled clock connection
Rev. B - final 19.07.2002 49/84
Copyright © Siemens AG 2005 All rights reserved
BID21669756_Zeitschaltuhr_einfach_DOKU_v20_e.doc
5.2 Software installation
Requirements: STEP7 V5.1 has already been installed with the NCM
package for Industrial Ethernet. In addition to STEP 7, ProTool V6 has
already been installed on your computer.
5.2.1 Loading the application software into the S7-CPU
The simplest way of loading the application software into the S7-CPU is via
the MPI. Connect the MPI interface of your PC with the MPI interface of the
S7-CPU. To complete the transfer you must perform the following steps:
Table 5-1 Loading the application software into the S7-CPU
Step Action Screenshot
1.
Open dialog box "Set PG/PC
Interface" with commands "Start
>Settings-> Control Panel-
PG/PC-Schnittstelle
einstellen [Set PG/PC
Interface]".
2.
Choose S7ONLINE as the “Access
Point of the Application“.
If this choice is not available to you,
create it by clicking
<Hinzufügen/Löschen
[Add/Remove]> (included in
options box under Access to
Application.
To Next Page
Loading...
