Time switch based on the S7-300/400 CPUs with simple HMI system
including radio-controlled clock connection
Rev. B - final 19.07.2002 51/84
Copyright © Siemens AG 2005 All rights reserved
BID21669756_Zeitschaltuhr_einfach_DOKU_v20_e.doc
Step Action Screenshot
6.
Open the delivered project in the
SIMATIC Manager and select the
SIMATIC station. Load the project
into the S7-CPU via the menu
“Zielsystem > Laden“ [PLC >
Download] or with the
button.
5.2.2 Load the application software into the panel
The ProTool project must be loaded into the respective HMI device. There
are 2 options:
• MPI transfer
• Serial transfer
In this example the MPI transfer is described. Connect the MPI interface of
your PC with the MPI interface of the panel, here the TP170A.
Note
The same procedure is also necessary when using an OP3. In this case you must
open the OP3 project (see step 3) instead of the TP170A project.
Table 5-2 Loading the application software into the panel
Step Action Screenshot
1.
For setting the PG/PC interface
perform steps 1 to 5 of chapter 5.2.1
2.
Open the delivered project in the
SIMATIC Manager.
3.
Select the project name, double click
on “TP170A“. The project is opened
in ProTool.
To Next Page
Loading...
