EasyManua.ls Logo

Siemens SIMATIC S7-400H - Page 458

Siemens SIMATIC S7-400H
504 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Function modules and communication processors supported by the S7-400H
S7-400H
458 System Manual, 03/2012, A5E00267695-11
Module Order No. Release One-sided Redundant
Communication processor
CP 443-5 Extended (PROFIBUS;
master on PROFIBUS DP)
1)
6GK7 443–5DX02–0XE0 As of product version 2
as of firmware V3.2.3
Yes Yes
Communication processor
CP 443-5 Extended (PROFIBUS
DPV1)
1) 2)
6GK7 443–5DX03–0XE0 As of product version 1
as of firmware V5.1.4
Yes Yes
6GK7 443–5DX04–0XE0 As of product version 1
as of firmware V6.0
Yes Yes Communication processor
CP 443-5 Extended (PROFIBUS
DPV1)
1) 2)
6GK7 443–5DX05–0XE0 As of product version 1
as of firmware V7.1
Yes Yes
1)
Only these modules should be used as external master interfaces on the PROFIBUS DP.
2)
These modules support DPV1 as external DP master interface module (complying with
IEC 61158/EN 50170).
FMs and CPs usable for distributed one-sided use
Note
You can use all the FMs and CPs released for the ET 200M with the S7-400H in distributed
and one-sided mode.
FMs and CPs usable for distributed switched use
Module Order No. Release
Communication processor CP 341–1
(point-to-point link)
6ES7 341–1AH00–0AE0
6ES7 341–1BH00–0AE0
6ES7 341–1CH00–0AE0
As of product version 3
6ES7 341–1AH01–0AE0
6ES7 341–1BH01–0AE0
6ES7 341–1CH01–0AE0
As of product version 1
as of firmware V1.0.0
6ES7 341–1AH02–0AE0
6ES7 341–1BH02–0AE0
6ES7 341–1CH02–0AE0
As of product version 1
as of firmware V2.0.0
Communication processor CP 342–2
(ASI bus interface module)
6GK7 342–2AH01–0XA0 As of product version 1
as of firmware V1.10
Communication processor CP 343–2
(ASI bus interface module)
6GK7 343–2AH00–0XA0 As of product version 2
as of firmware V2.03
Counter module FM 350–1 6ES7 350–1AH01–0AE0
6ES7 350–1AH02–0AE0
As of product version 1
Counter module FM 350–2 6ES7 350–2AH00–0AE0 As of product version 2
Control module FM 355 C 6ES7 355–0VH10–0AE0 As of product version 4
Control module FM 355 S 6ES7 355–1VH10–0AE0 As of product version 3
High-speed Boolean processor FM 352–5 6ES7352–5AH00–0AE0 As of product version 1
as of firmware V1.0.0

Table of Contents

Other manuals for Siemens SIMATIC S7-400H

Related product manuals