S7-400H
System Manual, 03/2012, A5E00267695-11
457
Function modules and communication processors
supported by the S7-400H
D
You can use the following function modules (FMs) and communication processors (CPs) on
an S7-400H automation system.
Note
There may be further restriction for individual modules. Refer to the information in the
corresponding product information and FAQ, or in SIMATIC NET News.
FMs and CPs which can be used centrally
Module Order No. Release One-sided Redundant
Counter module FM 450 6ES7 450–1AP00–0AE0 As of product version 2 Yes No
6DD 1607-0AA1 As of firmware 1.1.0 Yes No Function module FM 458-1 DP
6DD 1607-0AA2 As of firmware 2.0.0 Yes No
6ES7 441–1AA02–0AE0 As of product version 2
6ES7 441–1AA03–0AE0 As of product version 1
as of firmware V1.0.0
Communication processor
CP 441-1 (point-to-point link)
6ES7 441–1AA04–0AE0 As of product version 1
as of firmware V1.0.0
6ES7 441–2AA02–0AE0 As of product version 2
6ES7 441–2AA03–0AE0 As of product version 1
as of firmware V1.0.0
6ES7 441–2AA04–0AE0 As of product version 1
as of firmware V1.0.0
Yes No
Communication processor
CP 441-2 (point-to-point link)
6ES7 441–2AA03–0AE0 As of product version 1
as of firmware V1.0.0
Yes No
6GK7 443–1EX10–0XE0 As of product version 1
as of firmware V2.7.3
Yes Yes Communication processor
CP 443-1 Multi (Industrial Ethernet,
TCP / ISO transport)
6GK7 443–1EX11–0XE0 As of product version 1
as of firmware V2.7.3
Yes Yes
6GK7 443–1EX20–0XE0 As of product version 1
as of firmware V2.1
Yes Yes Communication processor
CP 443-1 Multi (Industrial Ethernet
ISO and TCP/IP 2-port switch)
Without PROFINET IO and
PROFINET CBA
6GK7 443–1GX20–0XE0
S7 connections via Gbit
port are not permissible
As of product version 3
as of firmware V2.0
Yes Yes
6GK7 443–5FX01–0XE0 As of product version 1
as of firmware V3.1
Yes Yes Communication processor
CP 443-5 Basic (PROFIBUS; S7
communication)
6GK7 443–5FX02–0XE0 As of product version 1
as of firmware V3.2
Yes Yes
To Next Page
Loading...
