Siemens SIMODRIVE 611-D - Page 111

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–103
SINUMERIK 840C / SIMODRIVE 611–D (DA)
105006 System crash – Please switch control off/on POWER ON
105006 !!! System crash – reboot !!! POWER ON
Power up
MMC is rebooted after 5 seconds
Either applications or the operating system has crashed or there is an MMC hardware fault
POWER ON
105007 Operator system initialization failed POWER ON
Power up
No power up of MMC
Internal system error during power up
Inform system service
105008 Hardware error: ...
–
Alarm 105006 is also output ––> see alarm 105006
DPR driver recognizes NMI because of a MMC hardware error: I/O channel check error or RAM parity error
POWER ON
105009 UMS too large ³ UMS not loaded OK softkey
Power up
UMS does not load
The UMS (customer or Siemens UMS) cannot be loaded with the current memory configuration because it is set
greater than in NC–MD 60000 (as from SW 4; up to SW 3, 512 kB fixed).
Change the memory configuration (as from SW 4); set MD 60000 accordingly.
105010 Master control initialization failed! POWER ON
Power up
No power up of MMC
Internal system error during power up
Inform system service
105011 Internal error: ... OK softkey
–
Alarms 105002, 105012 or 105013 are also output ––> see these alarms
Internal system error
See alarms 105002, 105012 and 105013
105012 Error in UMS ³ UMS not loaded OK softkey
Power up
UMS does not load
More detailed error diagnostics are entered in the log with message 105011
Check customer UMS, POWER ON
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description