Siemens SIMODRIVE 611-D - Page 119

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–111
SINUMERIK 840C / SIMODRIVE 611–D (DA)
110010 Workpiece archiving in punch tape format only OK softkey
DATA IN-OUT / DATA OUTPUT / WORKPIECES
–
A workpiece or job list can only be archived in punch tape format
Select punch tape format via toggle field
110011 There is no error log OK softkey
Error log
None
No error log was created for the previous data transfer
–
110012 Selected data cannot be printed OK softkey
DATA IN-OUT / PRINT
–
Selected data cannot be printed
Select data (e.g. MPF ..) which can be printed
110013 There is no job list for printer OK softkey
DATA IN-OUT / PRINT / JOB LIST
–
The printer has no job to process at the moment
–
110015 Floppy was not formatted OK softkey
DATA IN-OUT / FORMAT / OK
Diskette not formatted
General error during formatting
Check disk drive/cable
110016 Floppy is write-protected OK softkey
DATA IN-OUT / DATA OUTPUT / ... / START
(INSERT NEXT DISKETTE)OK
DATA IN-OUT / FORMAT / OK
Data are not stored or diskette is not formatted
The diskette tab is in the wrong position
Remove write-protection or insert another diskette
110017 No floppy inserted OK softkey
DATA IN-OUT / DATA OUTPUT / ... / START
DATA IN-OUT / DATA INPUT / START
(INSERT NEXT DISKETTE)
OK DATA IN-OUT / FORMAT / OK
–
There is no diskette in the floppy disk drive
Insert diskette
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description