04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–112
SINUMERIK 840C / SIMODRIVE 611–D (DA)
110018 Interface ... not initialized OK softkey
DATA IN-OUT / DEVICES / SELECTION
Data transfer not possible
Interface incorrect or not parameterized
Select suitable interface file and reparameterize. If floppy selected, floppy drive must be connected to interface.
110019 Observe error log OK softkey
DATA IN-OUT / (INPUT OR OUTPUT)
–
Errors occurred during data transfer. The data concerned are listed in the logs and must be checked.
Cause: Data already exist, overwriting not desired.
No read/write authorization when reading in again, incorrect punch tape format
Rectify the cause (if possible) and read in again
110020 Floppy is not formatted OK softkey
DATA IN-OUT / (INPUT OR OUTPUT) / START
(INSERT NEXT DISKETTE) OK
Data are not read in/written
The floppy is either not formatted or incorrectly formatted
Insert formatted diskette
110021 Error on reading the archive OK softkey
DATA IN-OUT / DATA INPUT / START
Data are not read
Archive file is faulty
–
110022 No workpiece selected OK softkey
LOAD NC / SHOPFLOOR SHEET
No display
Selected data are not workpieces
Select workpiece under LOCAL or GLOBAL
110023 There are no comments for ... OK softkey
LOAD NC / SHOPFLOOR SHEET / COMMENT
–
No comment available for current workpiece
Enter comment in program
110024 Archive list/job list is empty OK softkey
DATA IN-OUT / DATA OUTPUT / ARCHIVE LIST
No data are being read out
No object in the archive list can be accessed
Check archive list
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
