04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–113
SINUMERIK 840C / SIMODRIVE 611–D (DA)
110025 Floppy is full OK softkey
DATA IN-OUT / DATA OUTPUT / ... / START
Wait
The diskette is full
Insert another diskette, continue by pressing the OK softkey
110026 Archive not created or not found OK softkey
DATA IN-OUT / DATA INPUT / START
DATA IN-OUT / DATA OUTPUT / ... / START
–
The archive has not been written or no archive has been found
Read in: Transfer another archive
Read out: Check data/archive or job list/transfer format
110027 ... is not an archive file OK softkey
DATA IN-OUT / DATA OUTPUT / ARCHIVE LIST
–
The selected data is not an archive list
Select archive list with data selector
110028 No machining operation for ... OK softkey
LOAD NC / SHOPFLOOR SHEET / MACHINING OPERATION
None
The selected workpiece does not have a machining operation
Create data
110029 Not a hexadecimal number OK softkey
DATA IN-OUT / DEVICES / EDIT / STORE
Data cannot be stored
Hexadecimal number: a–f, A–F, 0–9
Correct
110030 Not a decimal number OK softkey
DATA IN-OUT / DEVICES / EDIT / STORE
Data cannot be stored/softkey operation cannot be executed
Decimal number: 0–9 without sign
Correct
110031 Interface still transmitting data OK softkey
DATA IN-OUT / DEVICES / SELECTION
Interface selection still being executed
Interface selection not possible during output (e.g. printing)
Delete print jobs or wait
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
ExplanationExplanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
