04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–114
SINUMERIK 840C / SIMODRIVE 611–D (DA)
110032 Error in archive file OK softkey
DATA IN-OUT / DATA INPUT / START
Data are either not read in or are read in with errors
Archive list is faulty
Correct
110033 Error on writing the archive OK softkey
DATA IN-OUT / DATA OUTPUT / ... / START
Data read out has been interrupted
Data is not evaluated by output medium (external device) (hardware fault)
Start again
110034 Timeout >= 0 and <= 60 seconds OK softkey
DATA IN-OUT / DEVICES / EDIT / STORE
DATA IN-OUT / DEVICES / SELECTION
Data cannot be stored/no device selection
Time must be in the specified range
Enter 0 ≤ time ≤ 60 seconds
110035 Wrong output medium parameterized OK softkey
DATA IN-OUT / FORMAT
DATA IN-OUT / PRINT
None
Parameterized floppy cannot be formatted, print command cannot be sent to parameterized universal interface
Change interface parameterization
110036 No data for ... OK softkey
LOAD NC / SHOPFLOOR SHEET / WORK SCHEDULE / MACHINING OPERATION
LOAD NC / SHOPFLOOR SHEET / WORK SCHEDULE
LOAD NC / SHOPFLOOR SHEET / BLANK
None
The corresponding data for the shopfloor sheet is not available
Create data
110037 The hard disk is full OK softkey
DATA MANAGEMENT / COPY / COPY / DATA IN-OUT / DATA INPUT /
START / SAVE NC / SOURCE NC / START
Data cannot be stored or created
–
Delete data no longer required
110038 Syntax error in job list line ... OK softkey
LOAD NC / START
DATA IN-OUT / DATA OUTPUT / WORKPIECES / START
Data are not archived/loaded into the NC
Syntax error in job list
Correct
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
