04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–115
SINUMERIK 840C / SIMODRIVE 611–D (DA)
110039 Data cannot be copied OK softkey
MANAGEMENT / COPY / PASTE / OK
Data are not copied
General error, e.g. data type may exist only once
E.g. delete data beforehand
110041 Error in NCK name OK softkey
DATA IN-OUT / DATA INPUT / START
Data in punch tape format are not read in their entirety
With data I/O in punch tape format the name is transmitted first. NCK data must begin with %MPF, %SPF, %TOA,
,%TEA, %SEA, %UMS, %RPA
Alter external data
110042 Syntax error in UMS file OK softkey
DATA IN-OUT / DATA INPUT / START
UMS file has been read in incorrectly
Error in data
Change external data
110043 Please use the proposed name OK softkey
MANAGEMENT / NEW / OK
Data are not created
–
Use the proposed name
110044 Too many print jobs in queue OK softkey
DATA IN-OUT / PRINT / START
Data are not sent to printer
The number of print jobs allowed is limited
Wait for the next print job to be completed or remove a print job from the job list
110045 ...signals transmission fault OK softkey
DATA IN-OUT / (DATA INPUT OR OUTPUT)
Data have either not been transferred at all or only partially or incorrectly
General error
Check other station and cable, reselect interface
110046 System error ... OK softkey
None
The last action has not been executed correctly
None
Inform system service
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
