Siemens SIMODRIVE 611-D - Page 124

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–116
SINUMERIK 840C / SIMODRIVE 611–D (DA)
110047 Interface is still active OK softkey
–
A data transmission session to this interface has not yet ended.
–
Terminate data transmission.
Applies as from SW 4.4
110048 Interface signals overrun OK softkey
DATA IN-OUT / DATA INPUT / START
Data are not read in correctly
Hardware problem
–
110049 Check interface parameterization OK softkey
DATA IN-OUT / DATA INPUT / START
Data are not read in correctly
Baud rate, parity, data length, number of stop bits incorrect
Alter interface data and reselect
110049 V24: Check interface parameters
Serial communication via V24
Data are not read in correctly.
If the transfer is interrupted in order to request the operator whether an already existing file is to be overwritten and
if no transfer protocol (e.g. RTS/CTS) has been defined, the transfer is interrupted and this message output.
Set type of protocol and select again.
Alarm from SW 6.3
110050 Floppy is already full OK softkey
DATA IN-OUT / DATA OUTPUT / ... / START
(INSERT NEXT DISKETTE) OK
Data are not are not archived
A full diskette has been inserted
Insert new diskette
110051 ... was not printed OK softkey
DATA IN-OUT / PRINT SERIAL / START
Not all of the specified object has been printed or it has not been printed at all
None
Check interface/printer
110052 ... signals timeout OK softkey
(DATA INPUT OR OUTPUT)
Data have not been read in or read out
No data were read in or collected in the parameterized time (TIMEOUT)
Check other station
110053 End of transmission without end identifier OK softkey
DATA IN-OUT / ... / ... / START
Data are not read-in/written or only partially
E.g. end of data without M02 or end identifier
Check other station and cable
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
09/01