04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–118
SINUMERIK 840C / SIMODRIVE 611–D (DA)
110061 No workpiece in job list line ... OK softkey
LOAD NC / START
Job list processing was interrupted
The workpiece name in the LOAD instruction does not exist
Change job list
110062 ... not found in job list OK softkey
LOAD NC / START
Job list processing was interrupted
The workpiece name in the LOAD instruction does not exist
Change job list
110063 No workpiece can be created here OK softkey
DATA IN-OUT / DATA INPUT / IN NEW WORKPIECE
None
A workpiece cannot be created at the current location
Select the directory PC/USER/LOCAL or PC/USER/GLOBAL
110064 Data type exists already OK softkey
Data management / new
Data management / insert from archive
File is not created / copied
The data type can only be created once in the current location.
First delete the existing file
110065 Not possible at present OK softkey
When data is output through V24 and saved to hard disk at the same time, e.g. from a MPF in the programming. If
file is processed in the PC editor.
Data is not transmitted.
–
Wait until the save operation has been concluded in the ASCII editor.
Applies as from SW 4.4
110066 Data in Siemens branch cannot be stored OK softkey
Data management / new
Data management / insert from archive
File is not created / copied
File cannot be created in Siemens branch.
Move to user branch
110067 Please enter correct archive name OK softkey
Data input
Data output
Function is not processed
The archive name must have the syntax of a file name
Enter correct name
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
