Siemens SIMODRIVE 611-D - Page 127

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–119
SINUMERIK 840C / SIMODRIVE 611–D (DA)
110068 Interface ... is disabled OK softkey
Data input
Data output
Function is not processed
The interface is busy with another application (PG SW, WOP, transfer job by PLC)
Wait until interface is free
110069 Tool list not available OK softkey
PROGRAMMING: shopfloor sheet / create TO file / OK
TO file is not created
–
Create tool list
110070 D number(s) exist more than once OK softkey
PROGRAMMING: shopfloor sheet / create TO file / OK
Data sets in TO file exist more than once
–
Process tool list
110071 Computer link: error number ... OK softkey
Computer link / error listing
Error during transmission
Error number reported during transmission
–
110100 There is no data/part program OK softkey
LOAD NC/START
Part program ... is not loaded
An item of data specified in the job list/part progam is not available
Correct job list
110101 There is no channel No./mode group/PLC No. OK softkey
LOAD NC, SAVE NC
Data is not saved or loaded
TOA, SEA4, RPA, ZOA (TOA, SEA4 > 0) RPA, ZOA ≥ 0
All data ≤ 4 (or 6 as from SW 4)
110102 No read/write access for ... OK softkey
Save NC / NC source / start
Data object is not created on MMC or cannot be read
No read only / write rights for the set user class, e.g. because PLC is in stop or keyswitch not processed in PLC
Turn keyswitch to position < 3 or set password
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description