04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–120
SINUMERIK 840C / SIMODRIVE 611–D (DA)
110103 Memory on NCK is full OK softkey
LOAD NC or basic display in AUTOMATIC mode, LOAD WORKPIECE
Part program will not be transferred
None
Delete part programs no longer needed from the NCK
110104 Error in data/part-program ... OK softkey
LOAD NC or AUTOMATIC basic display, LOAD WORKPIECE
Data are not transferred or only partly
S NC data to be loaded have errors
S Read error on hard disk when executing from hard disk
Check data
110105 Error during job processing OK softkey
LOAD NC, SAVE NC or AUTOMATIC basic display, LOAD WORKPIECE
–
–
–
110107 NC data/part program cannot be created here OK softkey
SAVE NC / NC SOURCE / START
MANAGEMENT / COPY / PASTE
DATA IN-OUT / BUFFER / INSERT
Data are not saved, copied or inserted in buffer
The data cannot be stored in the current directory
Select a different directory
110108 There is no workpiece . . . OK softkey
(AUTOMATIC MODE)
Workpiece will not be loaded
The workpiece required by the NCK does not exist in the MMC
Check entered names
110109 Only workpieces/NCK data can be loaded OK softkey
LOAD NC / START
None
Only workpieces or NCK data can be loaded
Using the data selector, select a workpiece under LOCAL or GLOBAL or an NCK object under a workpiece or
from NC data
110110 No access to SPF0 OK softkey
SAVE NC / NC SOURCE / START
SPF0 is not saved
The name SPF0 is not permissible
Deselect from SPF1
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
