04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–121
SINUMERIK 840C / SIMODRIVE 611–D (DA)
110111 ... being processed or cycle inhibit OK softkey
SAVE NC / NC SOURCE / START / LOAD NC / START
Data will not be saved to MMC or loaded in NCK
The part program either has cycle disable or is being processed
Remove disable or discontinue processing
Applies up to SW 2
110112 ... is not a correct NCK name OK softkey
LOAD NC / START
Data are not transferred to NC
Error in part program name, e.g. MPF_1
Correct name in MMC
110113 No communication to NCK OK softkey
(Power up) LOAD NC / START SAVE NC / NC SOURCE
No data transfer
There is no connection to the NCK. A more detailed error diagnosis is entered in the alarm log with message
105011 and possibly 105030 to 105039. Incorrect MDs e.g. IPO cycles too short.
Inform system service
110114 ... transmitted incompletely OK softkey
Abort AUTOMATIC basic display
LOAD NC / START / ABORT
SAVE NC / NC SOURCE / START / ABORT
The file has not been transmitted in its entirety to the MMC or the NCK
It may no longer be possible to send the complete file to the NCK
Save the complete file from the NC again and/or transfer it completely to the NCK
110115 ... : Line is too long OK softkey
LOAD NC / START
Incomplete data transfer
Line may not contain more than 120 characters without blanks or 120 characters with blanks in the comments
section.
Alter using editor
Applies up to SW 2
110116 No data transmitted for ... OK softkey
LOAD NC / ... / START / SAVE NC / ... / START
–
No transferable data was selected
Select data that can be transmitted / correct job list
110117 Wrong channel number OK softkey
SAVE NC /. .. / START
No data transmission
The channel number must be 0 4 ( 6 as from SW 4)
–
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
