Siemens SIMODRIVE 611-D Diagnostics Guide

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–171
SINUMERIK 840C / SIMODRIVE 611–D (DA)
165027 Loading from on-line to on-line not possible OK softkey
Loading MD files
Function is not executed
Only user or STANDARD data can be loaded
–
165028 BOOT is no valid file name OK softkey
Edit new, editing, saving, inserting MD files
Function is not executed
The name cannot be used for user files
Enter a different name.
165029 Boot files cannot be loaded OK softkey
Loading MD files
–
Boot files are automatically loaded on NCK reset
–
165030 There is no file with power section selection OK softkey
Drive MD/module selection
Power section cannot be selected
There is no system file
Please notify Siemens Service
Applies as from SW 4
165031 No communication to the MSD OK softkey
Saving, loading machine data
Function is not executed
Transmission either not possible or transmission interference
Repeat operation
Applies for SW 3 only
165032 MSD has not taken any standard values OK softkey
Drive MD, spindle (MSD): select motor
Drive is not parameterized
There are no standard data for this motor/PS combination
Select a different motor or motor from another manufacturer
165033 Conversion has not been switched off OK softkey
Loading drive machine data
Illegal data in drive
The alarm can also occur when drive MD are being transmitted if a boot file already exists.
Repeat operation, press softkey ”General reset” in the initial clear mode and reload the drive data.
Applies as from SW 5.4.
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description
01/99

Siemens SIMODRIVE 611-D Specifications

General

Brand	Siemens
Model	SIMODRIVE 611-D
Category	Control Unit
Language	English