Siemens SIMODRIVE 611-D Diagnostics Guide

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–174
SINUMERIK 840C / SIMODRIVE 611–D (DA)
165047 No curve parameterized OK softkey
Copy to clipboard and paste from clipboard in the IKA relationships display selected “with” curve.
Function is not performed
S The curve number is not parameterized
S Start or end pointer of the curve is not parameterized
S The start pointer is greater than the end pointer
S This information cannot be read (e.g. <on-line>, NCK power-up)
Select “without” curve using the toggle key or press the Abort key and parameterize the curve.
Applies as from SW 4
165048 No drift compensation performed for axis ... OK softkey
“Drift compensation” softkey in Service display
Function not carried out.
Internal error
None
Alarm in SW 5 and higher
165049 Axis ... not available OK softkey
“Drift compensation” softkey in Service display
Function not carried out.
The selected axis is not active, e.g. because it has just been set up.
Perform Power on, repeat action.
Alarm in SW 5 and higher
165050 Axis ... to be stopped first OK softkey
“Drift compensation” softkey in service display
Function not carried out.
Drift compensation only possible in Reset.
Stop program, press Reset, repeat action.
Alarm in SW 5 and higher
165051 NQFK data not backed up OK softkey
“Save on hard disk” softkey in the File functions menu in the Diagnosis/Start-up/Machine data display
The NQFK data have not been saved
System error
Please notify Siemens Service
Alarm in SW 5 and higher
165052 NQFK data for axis ... not saved OK softkey
“Save on hard disk” softkey in the File functions menu in the Diagnosis/Start-up/Machine data display
The NQFK data for the stated axis have not been saved.
The stated axis may have been incorrectly parameterized.
Check parameterization and repeat procedure.
Alarm in SW 5 and higher
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description

Siemens SIMODRIVE 611-D Specifications

General

Brand	Siemens
Model	SIMODRIVE 611-D
Category	Control Unit
Language	English