Siemens SIMODRIVE 611-D Diagnostics Guide

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–175
SINUMERIK 840C / SIMODRIVE 611–D (DA)
165053 NQFK data... not loaded OK softkey
“Load from hard disk” softkey in the File functions menu in the Diagnosis/Start-up/Machine data display
The NQFK data have not been loaded.
System error
Please notify Siemens service.
Alarm in SW 5 and higher
165054 NQFK data for axis ... not loaded OK softkey
“Load from hard disk” softkey in the File functions menu in the Diagnosis/Start-up/Machine data display
The NQFK data of the stated axis have not been loaded.
The NQFK ASCII file of the stated axis is defective or not compatible.
Delete or correct file, repeat procedure.
Alarm in SW 5 and higher
165055 Equivalent circuit data have not been calculated OK softkey
Softkey “Calculate equivalent circuit diagram”
Invalid data in drive.
–
Repeat action
Alarm in SW 5 and higher
165056 Carry out safety acceptance test OK softkey
Softkey ”Accept safe functions”
–
Without acceptance test, the operator’s life and limb are at risk.
The acceptance test must be performed in accordance with the valid safety regulations.
Applies as from SW 5.4
165057 Sisitec data TEA1 axis read error OK softkey
Softkey ”Accept safe functions”
The function has not been performed.
–
If necessary, first start up the axis.
Applies as from SW 5.4
165058 Sisitec data TEA3 drive write error OK softkey
Softkey ”Accept safe functions”
The function has possibly been performed incompletely, data may be inconsistent.
–
If necessary, first start up the drive.
Applies as from SW 5.4
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description

Siemens SIMODRIVE 611-D Specifications

General

Brand	Siemens
Model	SIMODRIVE 611-D
Category	Control Unit
Language	English