Siemens SIMODRIVE 611-D Diagnostics Guide

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–177
SINUMERIK 840C / SIMODRIVE 611–D (DA)
165065 Result field weakening speed < rated speed OK softkey
Softkey ”Calculate equivalent circuit diagram data (MSD only)”
The equivalent circuit diagram data have not been calculated, the field weakening speed (MD 1142 and 2142) can
now be modified manually.
The calculated field weakening speed is smaller than the rated speed (MD 1400 and 2400). This WarnNote is dis-
played if rated voltage plus the voltage drop at the series reactor exceed 400V.
Correct value of ”field weakening speed” manually.
Applies as from SW 5.4
165066 Current controller gain (MD 1120) not calculable OK softkey
Softkey ”Calculate controller data (FDD only)”
The controller data have been calculated, the machine data concerned has been given a suitable default value.
The calculated current controller gain is < 0.
If necessary, correct value and repeat function.
Applies as from SW 5.4
165067 Default value (MD x15) cannot be calculated OK softkey
Softkey ”Calculate controller data (MSD only)”
The controller data have been calculated, the machine data concerned has been given a suitable default value.
The result calculated was a default value  0.
If necessary, correct value and repeat function.
Applies as from SW 5.4
165068 Magnetizing reactance (MD x14) not allowed OK softkey
Softkey ”Calculate controller data (MSD only)”
The controller data have been calculated, the machine data concerned has been given a suitable default value.
The value 0 has been entered for the magnetizing reactance (MD1141 and MD 2141).
If necessary, correct value and repeat function.
Applies as from SW 5.4
165069 Leakage reactance (MD x139/MD x140) not allowed OK softkey
Softkey ”Calculate controller data (MSD only)”
The controller data have been calculated, the machine data concerned has been given a suitable default value.
The value 0 has been entered for one of the leakage reactances (MD 1139, 1140, 2139, 2140).
If necessary, correct value and repeat function.
Applies as from SW 5.4
165070 Rated frequency (MD x134) not allowed OK softkey
Softkey ”Calculate controller data (MSD only)”
The controller data have been calculated, the machine data concerned has been given a suitable default value.
The value 0 has been entered for the rated frequency (MD 1134 and MD 2134).
If necessary, correct value and repeat function.
Applies as from SW 5.4
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
1 Alarms
1.5.1 Alarm description

Siemens SIMODRIVE 611-D Specifications

General

Brand	Siemens
Model	SIMODRIVE 611-D
Category	Control Unit
Language	English