Siemens SIMOTICS T-1FW6 - Scope of Delivery; Preassembled Built-In Torque Motors with Cooling Jacket; Preassembled Built-In Torque Motor with Integrated Cooling

Frame size Cooling jacket Integrated cooling
with one cooling circuit
(only main cooler)
Integrated cooling
with two cooling cir‐
cuits
(main cooler and preci‐
sion cooler)
1FW6230   X
1FW6290   X
3.4.2 Scope of delivery
3.4.2.1 Preassembled built-in torque motors with cooling jacket
• Stator with a cooling jacket; one cable for the power connection and one cable for the signal
connection with connector or open core ends
• The rotor is secured in the stator by means of transport locks and is protected using a spacer
󹪝lm
• Transportation locks with spacers and screws
• O-rings (quantity: 2)
• 2rating plates
• Safety instructions
Note
Supplied as individual components
Stator and rotor as individual components are supplied without transport locks with spacers and
screws.
A spacer foil is supplied with stators as individual components.
3.4.2.2 Preassembled built-in torque motor with integrated cooling
• Stator with ready-to-connect cooling; one cable for the power connection and one cable for
the signal connection with connector or open conductor ends
• The rotor is secured in the stator by means of transport locks and is protected using a spacer
󹪝lm
• Transportation locks with spacers and screws
• Rating plate (attached); additional loose rating plate
• Safety instructions
Description
3.4Design
1FW6 built-in torque motors
Operating Instructions, 09/2022, A5E52220812B AA 43