6. Fix the stator and rotor using the transport locks. To do this, tighten the bolts with the
specied tightening torques according to the table "Required property classes and tightening
torques for stator and rotor."
7. Remove the spacer foil. When the stator and rotor are correctly centered, the spacer lm can
be easily removed by hand.
❒
5.4 Specication of the installation side
Permissible installation side
Note
Only mount the stator and rotor on one side of the ange. It is not permissible to mount the
stator and rotor at both ange sides.
As a result of the inherent design, for the following motors, mounting is only permissible at the A
ange.
Table 5-3 Mounting at the A ange
1FW616 1FW619 1FW623 1FW629
1FW6160-xxB10-2Pxx 1FW6190-xxB10-2Pxx 1FW6230-xxB15-0Wxx 1FW6290-xxB07-2Pxx
1FW6160-xxB15-2Pxx 1FW6190-xxB15-2Pxx 1FW6230-xxB20-0Wxx 1FW6290-xxB11-2Pxx
1FW6160-xxB15-0Wxx 1FW6190-xxB15-0Wxx 1FW6290-xxB15-2Pxx
1FW6160-xxB20-2Pxx 1FW6190-xxB20-2Pxx 1FW6290-xxB20-2Pxx
1FW6160-xxB20-0Wxx 1FW6190-xxB20-0Wxx
Installation
5.4Specication of the installation side
1FW6 built-in torque motors
Operating Instructions, 09/2022, A5E52220812B AA 73
To Next Page
Loading...
Need help?
General