Siemens SIMOTICS T-1FW6 - Preparation for Use

Preparation for use
4
WARNING
Risk of death and crushing as a result of permanent magnet 󹪝elds
Severe injury and material damage can result if you do not take into consideration the safety
instructions relating to permanent magnet 󹪝elds.
• Refer to Chapter "Danger from strong magnetic 󹪝elds (Page28)".
Keep these operating instructions so that they are accessible at all times. Please provide these
operating instructions to the appropriate personnel.
WARNING
Incorrect packaging, storage and/or incorrect transport
Risk of death, injury and/or material damage can occur if the devices are packed, stored, or
transported incorrectly.
• Always follow the safety instructions for storage and transport.
• Before transporting or lifting machines or parts machines, lock the rotary axes so the they
cannot accidentally rotate. This is necessary, as the axes are not self locking.
• Always correctly and carefully carry out storage, transport and lifting operations.
• Only use suitable devices and equipment that are in perfect condition.
• Only use lifting devices, transport equipment and suspension equipment that comply with
the appropriate regulations.
• IATA regulations must be observed when components are transported by air.
• Mark locations where rotors are stored with warning and prohibition signs according to the
tables in the Chapter "Supplied pictograms"
• Observe the warning instructions on the packaging.
• Always wear safety shoes and safety gloves.
• Take into account the maximum loads that personnel can lift and carry. The motors and their
components can weigh more than 13kg.
• Torque motors and rotors must always be transported and stored in the packaged condition.
– Replace any defective packaging. Correct packaging o󹪜ers protection against sudden
forces of attraction that can occur in their immediate vicinity. Further, when correctly
packaged you are protected against hazardous motion when storing and moving rotors.
– Only use undamaged original packaging.
1FW6 built-in torque motors
Operating Instructions, 09/2022, A5E52220812B AA 59