Operating modes
© Siemens AG 2003 All Rights Reserved
SIMOTION Safety Unit (AP) - Edition 06.2003
2-15
2.2.3 Continuous stroke (operating mode 3)
Definition
This operating mode requires the implementation of suitable safety measures and
an automated feed and removal of parts. After a start pulse, the press continues
running until it is brought to a standstill by a stop signal.
Depending on the selections made in the enable mask, the press either stops in
the TDC or comes to an immediate standstill.
Parameterization
Figure 2-5 Enabling of operating mode 3
To Next Page
Loading...
