Siemens Simotion TM 121C - Documentation of Outputs (Notes); Documentation of System Data

Documentation
© Siemens AG 2003 All Rights Reserved
10-72 SIMOTION Safety Unit (AP) - Edition 06.2003
10.2 Documentation of outputs (notes)
• Outputs 2 A
X6
Pin Description Cable Notes
1
2
3
4
5
6
7 Emergency stop P
8 Emergency stop N
• Outputs 0.5 A
X2
Pin Description Cable Notes
1 Output P Cycle 1
2 Output P Cycle 2
3
4
5 Output P Cycle 3
6 Output P Cycle 4
7
8 Error message
10.3 Documentation of system data
The CRC checksum should be entered on the label on the back of the memory
card and on the label located on the housing next to the memory card.
A complete function text must be performed after changes are made to the
parameterization, whether after the equipment is exchanged or
after the memory card is replaced (see Chapter 2.2 Device manual).