Siemens SIMOTION User Manual

Note: When used as a digital output, the contact must be supplied with voltage.
WARNING
Brief voltage peaks may occur at the analog outputs when the supply voltage is switched on
or off.
For this reason, it is important to make sure that the enable signals are wired correctly and
that the necessary safety regulations are met.
Stepper drives
Signals:
Interfaces
4.5 Onboard drive interface (C230-2, C240)
SIMOTION C
Operating Instructions, 11/2016, A5E33441428B 51

Siemens SIMOTION Specifications

General

Power Supply	24 V DC
Interfaces	PROFIBUS, PROFINET, Ethernet
Product type	Control Unit
Series	SIMOTION D
Display Output	VGA