Siemens SINAMICS G120 - Page 729

Index
C-729
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Function diagrams Signals and monitoring
functions
Load monitoring, 2-639
Monitoring functions 1, 2-643
Monitoring functions 2, 2-644
Speed signals 1, 2-636
Speed signals 2, 2-637
Thermal I2t motor model
(PEM, p0300 = 2xx), 2-642
Thermal monitoring, motor, 2-641
Thermal monitoring, power module, 2-640
Torque signals, motor locked/stalled,
2-638
Function diagrams Technology controller
Closed-loop control, 2-634
Fixed values, binary selection
(p2216 = 2), 2-631
Fixed values, direct selection (p2216 = 1),
2-632
Motorized potentiometer, 2-633
Function diagrams Technology functions
Bypass, 2-627
DC brake (p0300 = 1), 2-623
Essential Service Mode, 2-626
Free Technology controller 1, 2, 3, 2-624
Hibernation, 2-629
Multi Zone Control, 2-625
Staging, 2-628
Function diagrams V/f control
Resonance damping and slip compensa-
tion, 2-579
V/f characteristic and voltage boost,
2-578
Vdc_max controller and
Vdc_min controller (V/f control,
PM230/PM240), 2-580
Function diagrams Vector control
Current setpoint filter, 2-592
Current/power/torque limits, 2-591
Display signals, 2-600
Field weakening characteristic, Id setpoint
(ASM, p0300 = 1), 2-595
Field weakening controller
(PEM, p0300 = 2), 2-597
Field weakening controller, flux controller
(ASM, p0300 = 1), 2-596
Flux control configuration, 2-589
Id setpoint (PEM, p0300 = 2), 2-594
Interface to the Power Module
(ASM, p0300 = 1), 2-598
Interface to the Power Module
(PEM, p0300 = 2xx), 2-599
Iq and Id controllers, 2-593
Kp_n/Tn_n adaption, 2-585
Pre-control balancing, acceleration mod-
el, 2-583
Speed control configuration, 2-588
Speed controller, 2-584
Speed setpoint, droop, 2-582
Torque setpoint, 2-586
Upper/lower torque limit, 2-590
Vdc_max controller and
Vdc_min controller, 2-587
G
General
Faults and alarms, 3-654
Function Diagrams, 2-499
Parameters, 1-8
H
Hibernation, 2-629
I
IASC, 3-656
Index
Parameters, 1-8
Index (Parameters), 1-15
Input/Output Terminals
Analog inputs, 2-512
Analog outputs, 2-512
Digital inputs, 2-512
Digital outputs, 2-512
L
List of Abbreviations, B-717