Siemens SINAMICS G120C - Dimensions [mm] and drilling patterns

Commissioning
4.2 Commissioning with BOP-2 operator panel
SINAMICS G120C, FSD ... FSF inverters
Compact Operating Instructions, 11/2016, FW V4.7 SP6, A5E39339884B AA
61
No.
Description
r0751
BO: CU analog inputs status word
r0752
CO: CU analog inputs input voltage/current actual
AI0 (terminals 3/4)
p0753
CU analog inputs smoothing time constant [ms]
r0755
CO: CU analog inputs actual value in percent, AI0
(terminals 3/4) [100 ≙ 100%]
p0756
CU analog input type (terminals 3, 4)
0
0 V ... +10 V
1
+2 V ... +10 V
2
0 mA ... +20 mA
3
+4 mA ... +20 mA
4 -10 V ... +10 V 8 No sensor con-
nected
p0757
CU analog input characteristic value x1
p0758
CU analog input characteristic value y1 [%]
p0759
CU analog input characteristic value x2
p0760
CU analog input characteristic value y2 [%]
p0761 CU analog input wire break monitoring response
threshold
p0762 CU analog inputs wire-break monitoring decelera-
tion time [ms]
p0764 CU analog inputs deadband [V]
p0771 CI: CU analog output signal source, AO 0 (termi-
nals 12, 13) [100 ≙ 100%]
r0772
CU analog output, output value currently referred
p0773
CU analog outputs smoothing time constant [ms]
r0774 CU analog output, output voltage/current actual
[100% ≙ p2001]
p0775 CU analog output activate absolute value genera-
tion
p0776
CU analog output type
0
0 mA ... +20 mA
1
0 V ... +10 V
2
+4 mA ... +20 mA
No.
Description
p0777
CU analog output characteristic value x1 [%]
p0778
CU analog output characteristic value y1 [V]
p0779
CU analog output characteristic value x2 [%]
p0780
CU analog output characteristic value y2 [V]
p0782 BI: CU analog output invert signal source, AO 0
(terminals 12,13)
r0785
BO: CU analog outputs status word
.00
1 = AO 0 negative
p0795
CU digital inputs, simulation mode
p0796
CU digital inputs, simulation mode setpoint
p0797
CU analog inputs, simulation mode
p0798
CU analog inputs, simulation mode setpoint
p0802
Data transfer with memory card as source/target
p0803 Data transfer with device memory as
source/target
p0804
Data transfer start
12 Transfer GSD / GSDML for PROFIBUS /
PROFINET onto the memory card
p0806
BI: Inhibit master control
r0807
BO: Master control active
p0809
Copy Command Data Set CDS
p0810
BI: Command data set selection CDS bit 0
p0819
Copy drive data set DDS
p0820
BI: Drive data set selection DDS, bit 0
p0826
Motor changeover, motor number
r0835
CO/BO: Data set changeover status word
r0836
CO/BO: Command data set CDS selected
r0837
CO/BO: Drive data set DDS selected
p0840
BI: ON/OFF 1
p0844 BI: No coast down/coast down (OFF2) signal
source 1