Siemens SINAMICS G120C - Dimensions and drilling patterns

Commissioning
4.2 Commissioning with BOP-2 operator panel
SINAMICS G120C, FSD ... FSF inverters
Compact Operating Instructions, 11/2016, FW V4.7 SP6, A5E39339884B AA
65
No.
Description
p1300
Open-loop/closed-loop control operating mode
0
V/f control with linear characteristic
1 V/f control with linear characteristic and
FCC
2
V/f control with parabolic characteristic
3 V/f control with parameterizable characteris-
tic
4 V/f control with linear characteristic and
ECO
5 V/f control for drive requiring a precise fre-
quency (e.g. textiles)
6 V/f control for drive requiring a precise fre-
quency and FCC
7 V/f control for parabolic characteristic and
ECO
19
V/f control with independent voltage setpoint
20
Speed control (without encoder)
p1302
V/f control configuration
p1310 Starting current (voltage boost) permanent
[100 % ≙ p0305]
p1311
Starting current (voltage boost) acceleration [%]
p1312
Starting current (voltage boost) when starting [%]
r1315
Voltage boost, total [100 % ≙ p2001]
No.
Description
p1320
U/f control programmable frequency f [Hz] and
voltage U [V] characteristic
…
p1327
p1330 CI: V/f control independent voltage setpoint
[100 % ≙ p2001]
p1331
Voltage limiting [V]
p1333
U/f control FCC starting frequency [Hz]
p1334 V/f control slip compensation starting frequency
[Hz]
p1335
Slip compensation, scaling [100 % ≙ r0330]
p1336
Slip compensation limit value [100 % ≙ r0330]
r1337
CO: Actual slip compensation [100 ≙ 100%]
p1338
V/f mode resonance damping gain
p1340
I
max
frequency controller proportional gain
r1343 CO: I_max controller frequency output
[100 % ≙ p2000]
p1349 U/f mode resonance damping maximum frequen-
cy [Hz]
p1351 CO: Motor holding brake starting frequency
[100 ≙ 100%]
p1352 CI: Motor holding brake starting frequency
[100 ≙ 100%]