Siemens SINAMICS G120P - Working with BOP

28
Operator Panels BOP-2 and IOP-2: Working with BOP-2
ESC key – takes you back to the
previous screen
Up key – changes selection
Down key – changes selection
OK key – confirms selection
OFF key – stops the motor in the
manual mode
HAND / AUTO key – switches the
command source between HAND and
AUTO mode
ON / RUN key – starts the motor in the
manual mode
2.2 Working with the BOP-2
The BOP-2 is equipped with seven buttons. For setup and parameterization only the UP and DOWN, OK
and ESC buttons are relevant. The ON, OFF and HAND/AUTO keys are needed for local operation.
1
4
7
6
5
4
3
1
2
2
3
5 6 7