29
• Press UP to access the next parameter
• In this case, P3 appears (P means that you can change the value of this parameter)
• Press OK to edit the parameter
• Use the UP and DOWN buttons to adjust the value
• Confirm the value by pressing OK
Operating mode
• Press ESC to enter the menu selection
• Use the UP and DOWN buttons to move the menu bar to PARAMS and press OK
• Press OK to select the standard level
Parameter list
To better understand the functionality of the buttons, you should be acquainted with the operating
mode: The Basic Operator Panel gives you access to a parameter list. The parameters are assigned
stored values that control the operation of the motor. However, not all the numbers are assigned.
The first parameter number that appears is displayed on the left side of the screen: r2 (r stands for read
only and means that you can only read this value but cannot change it). The parameter value of the
selected number is shown on the right-hand side.
Example
If you want to change any param-
eter using the parameter list, you
are requested to choose a filter
level (Standard or Expert). The
standard level limits the available
parameters, thus limiting the risk
of dangerous parameter settings.
The Expert Level allows you to
access all parameters.
NOTE
Example
ESC
ESC
To Next Page
Loading...
