63
Creating a new project (Step 1): Give the project a name and click “Next” to access
PG/PC Set interface (Step 2): Check that “DEVICE” is set as access point.
If not, click “Access point” and set “DEVICE” in the dialog box
Check that “S7USB” is set as interface. If not, click “PG/PC”
Open the dropdown menu and select “AccessPoint of the Application”
Choose the command “Device (STARTER, SCOUT) --> to S7USB”
In the lower section called “Interface Parameter Assigned Used” select “S7USB”
Close with OK and click “Next”
3
4
2
5
6
7
8
7
8
5
6
2
3
4
To Next Page
Loading...
