Description
3
3.1 Area of application
The current-source DC-link converter is used for continuous speed adjustment of synchronous
motors with continuous power above 1 MW. The converter is suitable for four-quadrant
operation without additional expenditure. This means driving and braking are possible in both
directions.
Starting converter
The output frequency typically lies between 0 and 50/60 Hz. The converter is used as a starting
device for the following driven machines, for example:
● Blowers
● Fans
● Compressors
● Gas-turbine sets
● Hydroelectric power generators
● Large synchronous motors on weak power systems
Continuous-duty converter
The output frequency typically lies between 0 and 105 Hz. The converter is used for the
variable-speed drive of the following driven machines, for example:
● Blowers
● Fans
● Pumps
● Turbo-compressors
● Reciprocating compressors
● Extruders and mixers
● Continuous-flow conveyors
● Marine propellers
● Drive in rod mills
3.2 Safety concept
The device and its associated components are subject to an extensive safety concept. When
used properly, the security concept guarantees safe installation, safe operation as well as safe
service and maintenance.
SINAMICS GL150 6SL38503UM114PA0Z
Operating Instructions Rev.201910301420 MUSTER 27
To Next Page
Loading...
