Siemens SINAMICS IOP-2 - Page 77

Options
9.2 Hand-held device
Intelligent Operating Panel 2 (IOP-2)
Operating Instructions, 06/2020, FW V2.6, A5E39549448B AH
75
Note
Battery lifetime
With the supplied rechargeable batteries in a fully
-charged state they should last for
approximately 10 hours; the use of normal "AA" batteries may last considerably less time.
Industrial environment
The IOP
-2 has been designed for use within a Class A Industrial environment only.
Disposal of batteries
The batteries supplied with the IOP
-2 must be disposed of in accordance with local and
national environmental policies.
Battery status
The battery status is displayed at the top right
-hand corner of the IOP-2 display.
Battery charging
If the batteries are put on charge and the batteries are fully discharged; the charging unit will
enter a 'pre
-charge' state. During the pre-charge state the LED will not be lit, therefore there
may be a delay before the charging LED lights up.
The IOP-2 has no internal power source, so to increase the IOP-2's versatility, the hand-held
device has been designed.
The complete list of converters that work with the IOP-2 are listed in
Introduction
(Page 11). The following list comprises the converters that require the hand-held kit because
the IOP-2 cannot be mounted directly on the converter:
• SINAMICS G120D-2 CU240D-2
• SINAMICS G120D-2 CU250D-2
• SINAMICS ET 200pro FC-2
• SINAMICS G110D
• SINAMICS G110M
Table 9- 1 Hand-held device order information
Order number
Item quantity
Item
Remarks
6SL3255-0AA00-4HA1
1
IOP-2
1
Hand-held module
1
Power supply unit
4
Rechargeable batteries
1.2 V 2100 mAh NiMH (see note below)
1
RS232 cable
3 m