Options
9.2 Hand-held device
Intelligent Operating Panel 2 (IOP-2)
76 Operating Instructions, 06/2020, FW V2.6, A5E39549448B AH
Note
Battery order information
The batteries supplied with the IOP
-2 Hand-held Kit should be replaced with exactly the same
type of batteries. The batteries that have been tested for use with the IOP
-2 are given below:
The batteries can be ordered from the following website: GP Batteries
(http://www.gpbatteries.com/INT/index.php
)
The layout of the IOP-2 hand-held device is shown in the figure below.
Figure 9-3 IOP-2 Handheld kit layout
1. Intelligent Operator Panel (IOP-2)
2. IOP-2 release catch
3. ON/OFF switch
4. Charging LED - ON when charging, OFF when charged
5. 9-pin Sub-D male connector (RS232)
6. Charging unit input
7. Battery compartment cover
8. IOP-2 retaining screw
To Next Page
Loading...
