Siemens SINAMICS V20 Series User Manual

Parameter list
7.2 Parameter list
SINAMICS V20 Inverter
156 Operating Instructions, 07/2012, A5E03728167
Parameter Function Range Factory
default
Can be
changed
Scaling Data
set
Data
type
Acc.
Level
[1] Product type
[2] Firmware version
[3] Firmware date (year)
[4] Firmware date (day / month)
[5] Number of inverter objects
[6] Firmware version
r0967 Control word 1 - - - - - U16 3
Displays control word 1. See r0054 for the bit field description.
r0968 Status word 1 - - - - - U16 3
Displays active status word of inverter (in binary) and can be used to diagnose which commands are
active. See r0052 for the bit field description.
P0969 Resettable system run
time counter
0 -
42949672
95
0 T - - U32 3
Resettable system run time counter.
P0970 Factory reset 0 - 21 0 - - - U16 1
P0970 = 1 resets all parameters (not user defaults) to their default values.
P0970 = 21 resets all parameters and all user defaults to Factory Reset state.
0 Disabled
1 Parameter reset
21 User Default Parameter Reset
Dependency: First set P0010 = 30 (factory settings).
Stop inverter (i.e. disable all pulses) before you can reset parameters to default values.
Note: The following parameters retain their values after a factory reset:
• r0039 CO: Energy consumption meter [kWh]
• P0014 Store mode
• P0100 Europe / North America
• P2010 USS / MODBUS baudrate
• P2011 USS address
• P2021 MODBUS address
• P2023 RS485 protocol selection
• P8458 Clone control
When transferring P0970, the inverter uses its processor to carry out internal calculations.
Communications are interrupted for the time that it takes to make these calculations.
P0971 Transfer data from RAM
to EEPROM
0 - 21 0 U, T - - U16 3
Transfers values from RAM to EEPROM when set to 1.
Transfers new user default values from RAM to EEPROM when set to 21.
0 Disabled
1 Start transfer
21 Start User Defaults transfer

Siemens SINAMICS V20 Series Specifications

General

Brand	Siemens
Model	SINAMICS V20 Series
Category	DC Drives
Language	English