Siemens SINAMICS V60 - Setpoints from NC

Controlled Power Module (CPM60.1)
26 A5E03975175-002, 04/2014
Note
Detailed description of individual display data can be found in Section 3.3 "Display data list" (Page 31).
3.1.3
Setpoints from NC
Machine Data
Designation
Unit
Axis
Setpoint
Description
31020 ENC_RESOL PPR X, Z (808D Turning)
X, Y, Z (808D Milling)
10,000 Encoder revolution (2,500) x
Multiplier (4)
31400 STEP_RESO
L
IPR X, Z (808D Turning)
X, Y, Z (808D Milling)
10,000 Steps per servo motor revolution