Controlled Power Module (CPM60.1)
10 A5E03975175-002, 04/2014
Technical data
Technical data for CPM60.1 Drive Modules
Rated output current 4 A 6 A 7 A 10 A
Max. output current 8 A 12 A 14 A 20 A
Rated output power 0.8 kW 1.2 kW 1.6 kW 2.0 kW
Rated input power 0.9 kW 1.4 kW 1.9 kW 2.3 kW
Rated motor torque 4 Nm 6 Nm 7.7 Nm 10 Nm
Application field Turning machines, milling machines, engraving, packaging, printing etc.
Configurable controller SINUMERIK 808D, SIMATIC S7-200 and SIMATIC S7-1200
Axis Single-axis drive
Display 6-digit, 7-segment LED display, two LED status indicators
Keys on panel 4 tact switch keys
Setpoint interface Pulse interface
Overload capability
Applicable load inerita ≤ 5 times of motor inertia
Control mode 1. Position control (Input mode: pulse + direction signals)
2. JOG mode
Input pulse frequency ≤ 333 kHz
Drive input 1. Servo enable 2. Alarm cancel
Drive output 1. Brake output 2. Servo alarm 3. Servo ready 4. Zero mark
Protection functions Overcurrent, overvoltage, undervoltage, overload, IGBT overtemperature,
overspeed, encoder abnormal protections, I
2
t detection
Encoder TTL encoder 2500p/r with U, V, W rotor position signal; one zero mark
Mains supply voltage Rated voltage: 3 AC 220 V to 240 V
Tolerance: - 15 % ~ + 10 %
50/60 Hz, unregulated DC-Link
Ambient temperature Operation 0 to 45 °C: without power derating (100% load);
45 to 55 °C: with power derating (by 0% at 45 °C up to
30% at 55 °C).
To Next Page
Loading...
