PLC Subroutines Manual
26 6FC5397-0FP40-0BA0, 08/2013
You can back up a PLC application from the permanent memory of the control using the PLC Programming Tool or a USB
stick.
To upload a PLC application using the PLC Programming Tool, proceed as follows:
→ 1.
Choose these two menus from the menu bar or click
in the tool bar to create a new and
empty PLC application.
2. Establish the communication between the control and the PLC Programming Tool.
You can establish the connection by using the following three methods:
● Establishing a connection with the RS232 interface (Page 13)
● Establishing a direct connection with the Ethernet interface (Page 17)
Establishing a network connection with the Ethernet interface (Page 20)
To Next Page
Loading...
