PLC Subroutines Manual
6FC5397-0FP40-0BA0, 08/2013
63
Example for calling subroutine 58
Subroutine 59 (MM_MCP_808D)
Purpose
To use subroutine 59, you must have licensed the optional Manual Machine Plus function for the SINUMERIK 808D
ADVANCED T (Turning). The subroutines 46, 58 and 59 must be used together. Normally, the spindle will be stopped after
you press the NC reset key. However, when a manual machine is started, you do not want to stop the spindle after pressing
the NC reset key. In this case, call subroutine 59 (MM_MCP_808D) after executing subroutine 37 (MCP_NCK). Then you do
not need to rewrite subroutine 37 (MCP_NCK).
To Next Page
Loading...
