PLC Subroutines Manual
6FC5397-0FP40-0BA0, 08/2013
31
2.
Click this button and the comparing begins. Wait for a few seconds, and then you can view the
compare results.
The transferred PLC application will be active in the working memory of the control after the system is started up. Then you
can view the detailed information about the currently active PLC application in the version display through the following
steps:
+ → →
In the PLC Programming Tool, right click the OB1 block and choose "Properties". In the opened OB1 property dialog, in the
comment text box, you can add your own additional information for the PLC application.
Then in the version display on the control, the added information is visible.
To Next Page
Loading...
