PLC Subroutines Manual
72 6FC5397-0FP40-0BA0, 08/2013
I2.2
I2.3 Normally open
I2.4 Coolant level too low Normally closed
I2.5 Cooling pump motor overload Normally closed
I2.6 Lubricant level too low Normally closed
I2.7 Lubrication pump motor overload Normally closed
I3.0 Reserved
I3.1 Reserved
I3.2 Reserved
I3.3 Reserved
I3.4 Reserved
I3.5 Reserved
I3.6 Reserved
I3.7 Reserved
I4.0 Handheld unit: axis X selected Valid at a high level
I4.1 Handheld unit: axis Y selected Valid at a high level
I4.2 Handheld unit: axis Z selected Valid at a high level
I4.3 Handheld unit: fourth axis selected Reserved
I4.4 Handheld unit: increment X1 Valid at a high level
I4.5 Handheld unit: increment X10 Valid at a high level
I4.6 Handheld unit: increment X100 Valid at a high level
I4.7 Handheld unit: enabled Valid at a high level
Q0.0 Working lamp
Q0.1
Q0.2 Chip forward
Q0.3 Chip backward
Q0.4 Cooling pump
Q0.5 Lubrication pump
Q0.6 Safety door open
Q0.7
Q1.0 Magazine rotating clockwise
Q1.1 Magazine rotating counter-clockwise
Q1.2 Magazine approaching spindle position
Q1.3 Magazine approaching original position
Q1.4 Tool release from the spindle
Q1.5
Q1.6
Q1.7 Handheld unit valid
To Next Page
Loading...
Need help?
General
